@jkandasa
I am not able to check right now on the CLI of the Rpi.
From the Web interface of Mycontroller under the status/Mycontroller server log menu I see the following:

2016-03-20 23:31:19,426 WARN [Thread-4] [org.mycontroller.standalone.mysensors.MySensorsMessageEngine:318] Internal Message[type:I_PRESENTATION,payload:null], This type may not be supported (or) not implemented yet
2016-03-20 23:31:32,939 WARN [Thread-4] [org.mycontroller.standalone.mysensors.MySensorsMessageEngine:318] Internal Message[type:I_PRESENTATION,payload:null], This type may not be supported (or) not implemented yet

Tonight I will check the whole log and will let you know.

@jkandasa
Hi,
Yes I did this. I did not upgrade but executed an new/clean install of Mycontroller version 0.0.3-alpha1.
I added the nodes/sensors to this new version and it worked. Then after an few days I experienced some unwanted behavior on the alarming part.
I was troubleshooting this and during this process I deleted all my working Nodes/sensors with the intention to add them again, but not luck. I was unable to add the nodes anymore.

@jkandasa Hi, I used to run on Mycontroller version 0.0.2-alpha6, And now I am running Mycontroller version 0.0.3-alpha1.

Kind Regards,
S_vankuik

Hi fellow users of Mycontroller and Mysensor,

I am seeking your guidance in my setup of the Mycontroller/Mysensor network, because it is not working anymore.
I am running the latest version of Mycontroller (0.0.3-alpha1) on my Raspberry Pi B (Rasbian Jessie). I have an Serial Gateway running. It worked perfectly with the previous version (0.0.2-alpha6) of Mycontroller, but I upgraded to the latest version (0.0.3-alpha1) and then I experienced some unwanted behavior on the alarming.
Unfortunately I was troubleshooting this and deleted all my working Nodes/sensors.
Now I want to add them again, but not luck.
I tried many things:

• Start/ stop the mycontroller services
• Tested the nodes on de Serial monitor within the Arduino IDE. All- nodes are sending the correct data.
• rebooted the Raspberry Pi
• Reinstalled Mycontroller
• Cleared the Eeprom of the Nodes and reloaded the Sensor and Serial Gateway sketches.
  But still not working
  I am running out of ideas. Is there someone who can shine a light on this?

Kind Regards,
s_vankuik