Posts made by BenCranston

@jkandasa Sure thing.

I have the firmware setup like this:

And then I try to upload a to two nodes at a time. the first node will get the code sent to it, the second will not.

There was nothing in the log to show an error..

Greetings. I see in the interface the ability to capture RSSI values from the gateway. However I'm totally not seeing how to present that to the controller. the stock mysensors serial gateway does not forward that data as far as I can tell. Any guidance would be greatly appreciated. thanks.

@jkandasa So the first thing I have found is that the SNAPSHOT will not firmware upgrade more than one device at a time. If I select several nodes which all should get new firmware and select the upload firmware action, only one node will be sent to and then it stops. I cannot get it to sent to another node without a stop/start cycle on the controller.

I'm running the controller on an A20 based BananaPi with a LowPowerLab Moteino as the gateway with an RFM69 radio.

I'm finding that response time between stimulus from a node (like a button push) and a rule running and sending a response (turn relay on) to another node is sluggish and noticeable to the end user.

I was initially confused by the rules acting on operations, but I think I've got it down now.

So that's my feedback right now as I continue to explore the software. thanks for letting me in on the SNAPSHOT!

@jkandasa I'd love to help test the 0.0.3-Alpha2-SNAPSHOT. Thanks sir!