Custom Widget question
So my question is, and due to delay, I may need to do this at the sensor rather than at MyC.
So from my earlier post, I am using MyC paired with MySensors over Ethernet, to control my home standby generator. Now, I have the relays piped into MyC, and they function, but one of them is going to control crank. So here is my question: Is there a variable to make a latched relay into momentary?
skywatch last edited by
@fdlou147 You can simply turn the relay on and off again in quick succession.... Or am I missing the point here?
jkandasa last edited by jkandasa
@fdlou147 I assuming that you want to turn ON two relays and turn OFF one relay after some seconds,
Main relay: R1
Secondary relay: R2
If so you can do in the following steps.
Create two Operations:
- Turn ON R2
- Turn OFF R2 with delayed option (delay in seconds)
Create a rule,
- When your Primary relay turned ON
- Execute the operations created on previous steps
Note: Ignore Sensor names here. I took it from my setup to make this example.
That actually will work! I'm looking for when I trip the secondary relay(generator starter circuit) it shuts off after x time so it's not constantly cranking when the Gen is fired.