Custom Widget question



  • Hey everyone.

    So my question is, and due to delay, I may need to do this at the sensor rather than at MyC.

    So from my earlier post, I am using MyC paired with MySensors over Ethernet, to control my home standby generator. Now, I have the relays piped into MyC, and they function, but one of them is going to control crank. So here is my question: Is there a variable to make a latched relay into momentary?



  • @fdlou147 You can simply turn the relay on and off again in quick succession.... Or am I missing the point here? 😉



  • @fdlou147 I assuming that you want to turn ON two relays and turn OFF one relay after some seconds,

    Assume,
    Main relay: R1
    Secondary relay: R2

    If so you can do in the following steps.

    Create two Operations:

    • Turn ON R2

    65ef71dc-76f1-48a9-bb6b-6332d7b46556-image.png

    • Turn OFF R2 with delayed option (delay in seconds)

    82298fd7-7a1c-4632-b5d5-b6c9fbc26f97-image.png

    Create a rule,

    • When your Primary relay turned ON
    • Execute the operations created on previous steps

    2b5d37f8-049b-4086-896c-a9e2f2442df2-image.png

    Note: Ignore Sensor names here. I took it from my setup to make this example.



  • That actually will work! I'm looking for when I trip the secondary relay(generator starter circuit) it shuts off after x time so it's not constantly cranking when the Gen is fired.


Log in to reply
 

Suggested Topics

5
Online

584
Users

469
Topics

2.9k
Posts