Hi to all,
i'm absolutely newbie at this forum. Today i have installed MyController on Raspi for my first time - easy and works great
Then i started to connect my NodeMCU & DHT22 to MyController. At this point no chance to understand how MyController works ... is there anywhere a userfriendly documentation to understand Gateway / Node / Ssonsor and how it works togehter? For e.g. when i install a Node (my fine working NodeMCU) i don't know what EUI is ...
So it looks now:
My ESP8266 is configured with ESP Easy Tool and works (show humidty and temp). On ESP i choosed Openhab MQTT.
Hope someone can help or have any idea.
Thanks in advance
@SmartMark Welcome to MyController community!!
What type of library are you using in your sketch(Node)? can you post your node sketch?
Node EUI is like node ID.
@jkandasa Hi, thanks for your quick answer! Ihave uploaded on my Test-ESP8266 a firmware which comes with ESP Easy Mega Tool, because it's very easy to handle it. So i have no special firmware uploaded through Arduino IDE (this what you meant?).
Today i found on the serverlog this interesting entry (many of them):
2019-02-04 15:11:46,100 ERROR [Thread-6] [org.mycontroller.standalone.provider.mc.McProviderBridge:64] Unable to process this rawMessage:RawMessage(gatewayId=1, data=13.90, subData=out_esp, isTxMessage=false, networkType=MY_CONTROLLER, timestamp=1549289506089) org.mycontroller.standalone.message.RawMessageException: Unknown message format, Topic:out_esp, Payload:13.90 at org.mycontroller.standalone.provider.mc.McpRawMessage.updateMQTTMessage(McpRawMessage.java:97) at org.mycontroller.standalone.provider.mc.McpRawMessage.<init>(McpRawMessage.java:64) at org.mycontroller.standalone.provider.mc.McProviderBridge.executeRawMessage(McProviderBridge.java:58) at org.mycontroller.standalone.message.McMessageUtils.sendToProviderBridge(McMessageUtils.java:577) at org.mycontroller.standalone.message.MessageMonitorThread.processRawMessage(MessageMonitorThread.java:107) at org.mycontroller.standalone.message.MessageMonitorThread.run(MessageMonitorThread.java:182) at java.lang.Thread.run(Thread.java:745)
Looks like that humidty value was sent from ESP but the message format seems to be wrong ....
@SmartMark MyController supports only for the following libraries,
First, Very thanks for this great project
i would ask is node(esp8266) with MyControllerDevice lib code(relay example) will be added automatic to the system or what the process exact.
i start the server and upload code (relay example) to my nodemcu and add the "esp devices gateway" but what is next ?? i stuck here.
@mostafa Can you show the edit page of the
ESP devices Gatewaypage?
This post is deleted!
This gateway i created not automatic created
@mostafa topic names are case sensitive. looks like on your Arduino sketch you have supplied
in_Esp. This should be
in_espand the same for